High-capacity model with optional longer lifting plates.
Audible alarm during the final lowering phase.
Ensuring maximum safety when the lift is in a standing position.
No cross rails (maximum accessibility in the working area).
Additions to run-up ramps for low-ground clearance vehicles.
Controlled speed during the initial lifting and final lowering phase.
The minimum height from the floor guarantees easy and rapid positioning of the vehicle on the lift. Ideal for mechanical repairs, tire shops, and rapid fit facilities. It is also a good choice for service reception areas.
Scissor lift with safety latch and wheel alignment
RAV 640N.2l at-a-glance
All lifts are supplied for recessed installation.
Ideal when working on vehicles with narrow tracks.
The new lift geometry simplifies the flush mounting pit construction.
All pivoting points are equipped with maintenance-free self-lubricating bushings.
The drive-on ramp kit enables to conversion of the lift from flush mounted to floor version.
Edge-free platforms that allow the turntables to be positioned over the entire surface of the platform width.
Lifts with big platforms, up to 4.6 m in length, are designed for maximum stability when loaded with large vehicles.
Pre-installed galvanized guide on the inner side of the platform, which allows fast and smooth sliding of the jacking beam.
The hydraulic synchronization of the platform movements is independent of the load distribution and is guaranteed by a patented hydraulic synchronization device.
